User 113021

I'm thinking about taking off the default black ones on the 6, and putting some color-matched GTs on. How would I go about taking them off, and then putting the new ones on?

fazm

push pins all along the bottom, then some in the fender area. I recommend getting replacement ones before you do it, as they have a tendency to break.

User 113021

I've never dealt with push pins before. How do you go about removing them?

fazm

i have panel poppers to do them with, but a flathead screwdriver will work.

tsaints1115

They`re a two piece retainer. When the center section is pushed in it causes the outer half to expand,retaining the part. To get them out you use a small flathead and coax the center section back out which will allow the parts to be pulled apart. They`re really much better than the old one piece christmas tree style that tended to break alot.

paulboy16

Ok a flathead screwdriver gets them sum of the way, but i recomend sum long nose plyers to pull them right out, becarefull! i smashed my hand intot he ground soo hard i snapped my thumbnail in 2 and it swelled up and bled for ages. and u can get the painted gt takeoffs for 100bucks shiiping from Diversified


Paul

The Toltek

I'm stopping by Diversified (hopefully tomorrow) to pick up a GT rear bumper. I hope they also have the lime side skirts in as well.
Which leads my to this ques... These "two piece retainer clips", where does one buy these? online, call the dealer, or maybe even from diversified?

paulboy16

the 2 peice retainers SHOULD come out and not break so u can reuse them, its the pop things that get fuxed up

Paul