Notices
V6 S197 General Discussion This section is for technical discussions pertaining specifically to the V6 variation of the 2005 and newer Ford Mustang.

I should have known.......

Thread Tools
 
Search this Thread
 
Old 08-26-2006, 10:04 AM
  #1  
RUNVUS
Thread Starter
 
RUNVUS's Avatar
 
Join Date: Feb 2006
Location:
Posts: 24
Default I should have known.......

I should have known when she came home with beer for me, something was up! Then this morning she takes me out to my Stang and shows me the damage she caused at the bank drive through......... She ripped up the black plastic under the passenger door. Apparently she got a little too close to the curb and scraped the hell out of it!

Any ideas what this will cost me?
RUNVUS is offline  
Old 08-26-2006, 10:34 AM
  #2  
HurricaneStang
4th Gear Member
 
HurricaneStang's Avatar
 
Join Date: Jun 2006
Location:
Posts: 1,165
Default RE: I should have known.......

The side rockers? like the flat black piece? If thats it then go here: http://www.newtakeoff.com/index.asp?...ID=8127....You can either get a gloss black to replace or get the color of your car. Not very expensive $200 plus shipping and you can put them on urself. Cheaper then going to the dealership they pry charge $150 for the part alone not to mention how much the labor is. I'll look around for ya to see if i can find some cheaper ive seen some somewhere otherwise those arent abd.
HurricaneStang is offline  
Old 08-26-2006, 10:38 AM
  #3  
HurricaneStang
4th Gear Member
 
HurricaneStang's Avatar
 
Join Date: Jun 2006
Location:
Posts: 1,165
Default RE: I should have known.......

Actually according to the site they charge $400 a piece for the molding so personally i would just go with either the black or the torch red panels and put them on yourself. I'm pretty sure they just attact with the retaining clips that are on the one you have. Just incase those are ruined though you can go to like autozone or something and pick somemore up there really cheap. Hope it goes good for ya.
HurricaneStang is offline  
Old 08-26-2006, 11:46 AM
  #4  
LiquidLenny
1st Gear Member
 
LiquidLenny's Avatar
 
Join Date: Jun 2006
Location:
Posts: 131
Default RE: I should have known.......

www.v6mustangstuff.com has those already painted under the take off's category. I think they are $79 a piece or something around that. I'm going to get a pair.
LiquidLenny is offline  
Old 08-26-2006, 11:48 AM
  #5  
LiquidLenny
1st Gear Member
 
LiquidLenny's Avatar
 
Join Date: Jun 2006
Location:
Posts: 131
Default RE: I should have known.......

Actually they are $69 a pair! That's a deal! Except shipping is $62 [&o]
LiquidLenny is offline  
Old 08-26-2006, 11:53 AM
  #6  
randy78045
6th Gear Member
 
randy78045's Avatar
 
Join Date: Jan 2006
Location: Laredo, TEXAS
Posts: 6,054
Default RE: I should have known.......

Beware of beer bearing women...
randy78045 is offline  
Old 08-26-2006, 12:35 PM
  #7  
Britinastang
2nd Gear Member
 
Britinastang's Avatar
 
Join Date: Apr 2006
Location:
Posts: 306
Default RE: I should have known.......

You should take on my policy

NO-ONE DRIVES MY CAR AND ESPECIALLY NOT MY MRS
Britinastang is offline  
Old 08-26-2006, 12:37 PM
  #8  
HurricaneStang
4th Gear Member
 
HurricaneStang's Avatar
 
Join Date: Jun 2006
Location:
Posts: 1,165
Default RE: I should have known.......

Wow nice find thats the one place i forgot to look at lol and i normally look there just to see if they added any new take off parts. So ya figure $140 for both then i dont know how much they charge for 2 to ship but either way its still cheaper then buying even one from the dealer....I might just get some in the gloss black to make the black door stripes!
HurricaneStang is offline  
Old 08-26-2006, 04:00 PM
  #9  
NickSezz
4th Gear Member
 
NickSezz's Avatar
 
Join Date: May 2006
Location: Nutley NJ
Posts: 1,207
Default RE: I should have known.......

its ok man...i hit an "insivible" curb and it ripped mine completely off and put a dent in the frame under it....dent wasnt too bad but i had to get a new rocker...someone on these forums offered me his 2 stock v6 ones for 90 bux shipped so i took his offer and fixed my car...your best bet is the gt takeoffs
NickSezz is offline  
Old 08-26-2006, 06:54 PM
  #10  
RUNVUS
Thread Starter
 
RUNVUS's Avatar
 
Join Date: Feb 2006
Location:
Posts: 24
Default RE: I should have known.......

Thanks Guys!

In addition to the beer I did get a little "something else" for her screw-up!

I have the V-6, are these GT's going to work on my car?

BTW: I knew you guys at this forum would be a great help!



Run
RUNVUS is offline  


Quick Reply: I should have known.......



All times are GMT -5. The time now is 10:43 PM.