Dual exhaust parts question...
#1
Dual exhaust parts question...
Hey all! I'm getting my dual exhaust installed tomorrow, and was wondering if I should let the mechanic fabricate the hanger holders for the driver's side, or should I go to the Ford dealer, and get the GT ones? Is this a part they normally keep in stock at the dealership?
Peace!
Scott
Peace!
Scott
#3
RE: Dual exhaust parts question...
ORIGINAL: merlinsrealm
I had mine fabricated........But I knew the people doing the job so I knew I would get mine done right.
Eric
I had mine fabricated........But I knew the people doing the job so I knew I would get mine done right.
Eric
Peace!
Scott
#4
RE: Dual exhaust parts question...
The muffler shop may have take-off GT hangers laying around. If the GT boys have modded their exhaust, the shop may still have their originnal hangers. The shop I used for duals had 4 in the back (but I had already gotten mine from Ford). Ask them about it.
As an aside, the shop would NOT cut my bumper due to liability concerns. I cut it myself using a palmed hacksaw blade, followed by a utility knife and finished off with 100-grit sandpaper wrapped around a soda can. Remember - measure twice and cut once
As an aside, the shop would NOT cut my bumper due to liability concerns. I cut it myself using a palmed hacksaw blade, followed by a utility knife and finished off with 100-grit sandpaper wrapped around a soda can. Remember - measure twice and cut once
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
21
04-04-2020 02:16 PM
tj@steeda
Steeda Autosports
0
09-01-2015 08:16 PM