where to cut??
#1
where to cut??
i plan on getting the dual exhaust system from ford racing within the next week or so and i dont really have a local muffler shop so i was considering doing it myself but im not sure where i have to cut and what not. if someone who has duals could help me out with this one. maybe some pictures?
#3
RE: where to cut??
there was a template that was printable floating around the forum. not sure who supplied it but it seemed pretty accurate. i myself measured the side edge of the bumper to the factory cutout and measured the width of the cutout and just repeated that on the driver side. this template that now exists wasnt around when i cut mine and i think it still came out damn good. muffler shop said it looked factory. the bumper cuts fairly easy with a razor sharp utility knife which is what i used.
#6
RE: where to cut??
ORIGINAL: Sancho805
there was a template that was printable floating around the forum. not sure who supplied it but it seemed pretty accurate. i myself measured the side edge of the bumper to the factory cutout and measured the width of the cutout and just repeated that on the driver side. this template that now exists wasnt around when i cut mine and i think it still came out damn good. muffler shop said it looked factory. the bumper cuts fairly easy with a razor sharp utility knife which is what i used.
there was a template that was printable floating around the forum. not sure who supplied it but it seemed pretty accurate. i myself measured the side edge of the bumper to the factory cutout and measured the width of the cutout and just repeated that on the driver side. this template that now exists wasnt around when i cut mine and i think it still came out damn good. muffler shop said it looked factory. the bumper cuts fairly easy with a razor sharp utility knife which is what i used.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM