Casco Upgrade question -

V6 S197 General Discussion This section is for technical discussions pertaining specifically to the V6 variation of the 2005 and newer Ford Mustang.

Casco Upgrade question

Old 10-13-2005, 11:41 PM
Island Stang
Thread Starter
Join Date: Mar 2005
Location: Hilton Head Island, SC
Posts: 14
Default Casco Upgrade question

I hit a GAS GRILL in the middle of the road that must have fallen of a truck a few weeks ago![:@]

SO, instead of paying a $500.00 deductible I am going to get the full upgrade kit from
Mike at Casco minus the bullit rims/tires as I already have them.

My question for you folks that did the Casco GT bumper cover-grille/skirts/rear bumper conversion:

What parts if any will I need to attach the bumper(s)grille skirts?

Thanks a lot.
Island Stang is offline  
Old 10-14-2005, 08:25 AM
Join Date: Sep 2005
Posts: 20
Default RE: Casco Upgrade question

for the rear, you just need some simple tools like a 1/4" rachet with a 1/2" socket if i remember correctly and a 6" extension to get the nuts out of the inside of the trunk that hold the bumper on and you will also need some sort of small screw driver to get the wheel well screws off with the tire in the way, like a stubby phillips, or 90 degress such as what i used. You'll need a flathead to take your plate off and something to pull out the wiring harness plastic pop in thingees that old the wiring harness onto the harness bracket that is mounted inside the rear bumper. The rear bumper wiring harness bracket is also held in place with rivets to the inside of the bumper, you will need to carefully remove the rivets as not to damage the harness bracket holes as you will need to re-rivet/zip tie them somehow inside the new rear bumper. Other then that, the rest is just snap and pop pretty much.

When i did this conversion from my v6 to the GT bumper, i thought it would all be snap and pop, but it wasn't. If you have any mechanical abilities what so ever, it's not hard, just be patient and take your time, so you won't damage anything you are uncertain of. I'm sure you will run into the same type of issues on the front bumper as well. Hopefully someone will read this that had done the front conversion and will offer some advice.
PATDOGG is offline  
Old 10-14-2005, 12:47 PM
2nd Gear Member
Join Date: Aug 2005
Posts: 408
Default RE: Casco Upgrade question

I would like to see some install instructions on a PDF or power point slide. I plan on getting a new front and rear bumper, once I do get those (in a few months) I'll create a power point slide.
burdweiser is offline  
Related Topics
Thread Starter
Last Post
4.6L (1996-2004 Modular) Mustang
09-18-2015 01:27 PM
2005-2014 Mustangs
09-17-2015 02:45 PM
2005-2014 Mustangs
09-08-2015 11:45 AM
S197 Handling Section
09-05-2015 04:42 PM

Thread Tools
Search this Thread
Quick Reply: Casco Upgrade question

Featured Sponsors
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.