Back Up Aid Removal
#1
Back Up Aid Removal
I installed a Roush rear valance with the square exhaust ports which did not come with the sensor ports. I disconnected the wiring but now get a check rear back up aid message. Is there anything else i need to do to disconnect the back up sensors?
#3
I would take it to the dealership and see if they can completely disable the electronics that control the sensors.
I have the sensors as well and looked into swapping them into a new bumper but it's a bit more involved than I'd like.
Here's a guy on another forum that did it himself:
http://www.allfordmustangs.com/forum...-diffuser.html
I have the sensors as well and looked into swapping them into a new bumper but it's a bit more involved than I'd like.
Here's a guy on another forum that did it himself:
http://www.allfordmustangs.com/forum...-diffuser.html
Thread
Thread Starter
Forum
Replies
Last Post
yourmom6990
3.7L V6 Technical Discussions
2
10-14-2015 10:08 PM
Shifty Magoo
Audio/Visual Electronics
0
08-25-2015 03:08 PM
dochawk
Classic Mustang General Discussion
7
08-25-2015 08:25 AM