REAR BLACKOUT DECAL ON SALE
#21
I received mine, its unrolled on my pool table with some cue sticks over it flattening out...
I'm wondering though, was I suppose to have a cutout for the GT badge? there is a cutout for the ford emblem, but not the GT badge. I suppose I can try to cut around it but that won't be too easy...
I'm wondering though, was I suppose to have a cutout for the GT badge? there is a cutout for the ford emblem, but not the GT badge. I suppose I can try to cut around it but that won't be too easy...
#22
just remove the badge and put it back on. if you try and cut it, you'll hate the results. so much easier to go to walmart and get some 3m automotive tape and simply put the logo back on later.
#24
sticking it to the vinyl won't hurt it, but if you're really concerned about it, just cut a hole in the vinyl smaller than the emblem, so that you don't see the edges of the vinyl and it is sticking to the car itself. new emblems are stupid expensive, i looked into getting new ones when i had my fenders blended to have my hood painted.
#29
Go to any R/C car type hobby store and buy the spray tint it should cost about 6 bucks a can. Two will get the job done. I would only spray two coats though, I did four, and its to dark in the daytime. I did two coats on the third brake light and its good.