Tired of these 2v heads
08-21-2008, 08:56 PM
#1
1st Gear Member
Thread Starter
Join Date: Aug 2008
Posts: 50
Tired of these 2v heads
Ok so i dont know about everyone else but Im sick of the 2v heads. So I am thinking about doing a cobra motor swap before I boost her. But I was wondering if there was an easier way because if I did the whole swap I would have to change computers and the harness just pain. Any way the cobra heads can just go on my block lol, that way I can just build the bottom end before boostin
08-21-2008, 09:13 PM
#5
stage 3 heads or wait for this ever illusive new 2v head design...that i dont even think will ever exist. but i say just get stage 3 heads and healthy cams and that will be pretty efficient for 2v'ers and boost.
08-21-2008, 09:35 PM
#7
4th Gear Member
Join Date: Jun 2007
Location: Cumberland County NJ
Posts: 1,369
It's probably no harder then installing upgraded 2v heads. But your going to also need coils since the 4v engine have a slightly different desighn. Also going to need timing chains, guides, front engine cover, Tune, injector harness. etc. So in the end it would be cheaper to upgrade your cylinder heads or even just swap a 4 v engine in.
08-21-2008, 09:38 PM
#8
6th Gear Member
Join Date: May 2006
Location: Ohio
Posts: 6,448
Look on ebay and the heads, cams, timing cover, exhaust manifolds and intake for around $1300. Extend the wires in the harness. Use your computer and get it tuned. Its really not that hard. Maybe an extra 2 hours of work over just swapping ported 2v heads.
