Install pony projection light on my GT 2013
#1
Install pony projection light on my GT 2013
Remove the door panel, you can easily find this instruction from youtube,
then need to drill a hole underneath the door metal frame, B position as shown in the picture below:
The picture of position B shooting from underneath:
Connect the wire to position A as shown in the picture:
Done! The part takes me ~$20 from Amazon. The dealer asked for >$300 for labor only, of course I don't accept
then need to drill a hole underneath the door metal frame, B position as shown in the picture below:
The picture of position B shooting from underneath:
Connect the wire to position A as shown in the picture:
Done! The part takes me ~$20 from Amazon. The dealer asked for >$300 for labor only, of course I don't accept
#5
Amazon.com : 2 x 5th Gen LED car door Ghost Shadow laser projector logo light for Ford Mustang : Automotive Electronic Security Products : Car Electronics
Not Ad. You can search mustang projection and will have a lot of selections.
#6
after drilling a hole like that you really need to seal up the exposed metal edges. best with both a layer of etching primer (let dry fully) and a couple layers of paint (let dry completely.) Else the doors are going to immediately start rusting there.
#7
To the OP - that looks really nice & the color is great. I have the stock puddle lamp pony's and now I wish they came with more color than just white.
#8
the funny thing is if you read the instructions on the site the OP linked, you're supposed to drill the hole in the plastic door trim panel. not the ****in' sheetmetal.
#9
Thank you so much, this is the step I missed. Does the glazing & Spot Putty works?
#10
Yes, I tried to find a place from the plastic trim panel and found it is very hard to access and finally gave up.