Vinyl Cutting
#5
I'm going to get it in black. Going to get the letters for the fenders done after christmas. The side of the mustang will look similar to this minus the number on the door.
Last edited by 1slow67; 12-14-2008 at 08:08 PM.
#6
Hmm i guess consult with Jmd first,
if he does it as a professiion he might be able to be more effiecient with this, meaning;
if i did it i would ahve to use a 2 foot wide peice of vinyl for the gt stripe for only 6 inches of it the rest owuld be waste (except the lettering) but if someone who was doing more volume they would have a use for the rest...
wait never mind as i was typing i realized you needed both sides, making perfect use of the whole 2 feet, i could draw up sometihng for you, then see what Jmd has to offer in comparison
if he does it as a professiion he might be able to be more effiecient with this, meaning;
if i did it i would ahve to use a 2 foot wide peice of vinyl for the gt stripe for only 6 inches of it the rest owuld be waste (except the lettering) but if someone who was doing more volume they would have a use for the rest...
wait never mind as i was typing i realized you needed both sides, making perfect use of the whole 2 feet, i could draw up sometihng for you, then see what Jmd has to offer in comparison
#7
I can buy the GT stripe on the bottom. I want to get the letters made. I can measure the space tomorrow to figure out how big I want to get them.
EDIT: I could get you guys to make the stripes too if just making the letters is a big waste of material.
EDIT: I could get you guys to make the stripes too if just making the letters is a big waste of material.
Last edited by 1slow67; 12-14-2008 at 08:38 PM.
#9
They don't make the GT200 part. It is that or GT204 since my 200 is bored .040 making it a 204.
Well after christmas I should have some money I could spend on these unless I sell some of the parts I have for sale right now.
Well after christmas I should have some money I could spend on these unless I sell some of the parts I have for sale right now.