Deviousfred

Thought I would give everyone a closer look at the Calvert/Moneymaker strut rods since there isn't too many pictures of them out there. Also got started on the install but ran out of time because I had to run my spring perches down to F15Falcon so that he could build me a set of his roller spring perches.

The only thing I would change on them is switch the aluminum cages to steel to make sure they hold up to cornering.











Mocked up in place.

I got a little bit into the install and they are not bolt-on, they required a bit of "dremelling" and drilling to get the bearing cages in place. WIll have a complete write up once I finish.
Fred