540RWHP on stock motor?
#1
540RWHP on stock motor?
Hey guys,
I was checking out JDM Engineering's website (New Jersey), and they claim that they can push the Rouscharger to 540RWHP on a stock motor.
http://www.teamjdm.com/roush.php
I just ordered a 2010 GT and was under the impression that the block couldn't handle this amount of boost. Even if it could, I didn't think it was safe for the stock parts. Can anyone help clarify this? Thanks in advance fellas.
I was checking out JDM Engineering's website (New Jersey), and they claim that they can push the Rouscharger to 540RWHP on a stock motor.
http://www.teamjdm.com/roush.php
I just ordered a 2010 GT and was under the impression that the block couldn't handle this amount of boost. Even if it could, I didn't think it was safe for the stock parts. Can anyone help clarify this? Thanks in advance fellas.
#2
They should clarify the blower........ The Roushcharger is based on the Eaton roots blower. We have seen #s up around 430-440rwhp with smaller blower pulley, custom CAI/MAF, etc.
The 540rwhp kit they are showing is with the Roush TVS R2300 supercharger. This is one bad blower. The blower rotors are the same design as used in the new S/C ZR1 vette.
My opinion, anything 500 and over is Pushing the stock internals.
Casey
The 540rwhp kit they are showing is with the Roush TVS R2300 supercharger. This is one bad blower. The blower rotors are the same design as used in the new S/C ZR1 vette.
My opinion, anything 500 and over is Pushing the stock internals.
Casey
Thread
Thread Starter
Forum
Replies
Last Post
M3hunter
S197 Handling Section
0
09-05-2015 03:42 PM