went to the dyno yesterday...
11-02-2008, 01:37 PM
#1
2nd Gear Member
Thread Starter
Join Date: Apr 2008
Location: Orange County, CA
Posts: 227
went to the dyno yesterday...
I was just curious to see what the lil 4.6 would put down on the dyno.... so i went to a GM performance shop on their opening day with alll my LS1 buddies. Wow lil scary huh! All i have is a C&L aluminum intake and brenspeed tune. The tuner laughed at it and said, "ill guess 245 to the wheels!" I said i think 285... Keep in mind this is a DynoJet, the best dyno and most conservative! I put down 288 hp and 306 torque! Not bad, does everyone have similar results with intake/tune and Pypes MM?
11-02-2008, 05:05 PM
#4
2nd Gear Member
Thread Starter
Join Date: Apr 2008
Location: Orange County, CA
Posts: 227
well the truth is guys, i am a GM guy! I have a 68 camaro.... hence my username. They are all my buddies though! The tune is just the 91 tune from brenspeed, we don't have 93 here in CA 
Thanks for the feedback though! I was curious though cuz i did run a good time at the track, see my sig
Thanks for the feedback though! I was curious though cuz i did run a good time at the track, see my sig
11-02-2008, 06:34 PM
#6
5th Gear Member
Join Date: Sep 2007
Location: Escondido, California
Posts: 2,018
Is that SAE or STD corrected numbers? SAE will give you about 4-5% lower numbers because the factor in the temp of about 76-77 degrees. Your numbers are similar to mine. With JLT, Magnpacks, Steeda UDP and Bamachips 91 tunes (race and tq) I put down anywhere from 296 to 298 rwhp and 306 to 309 rwtq. These are SAE corrected numbers.
About 2 weeks ago JBA performance had a dyno day. There where mostly mustangs there, but there where a few Firebird/Transams and Camaro/Z28s. Everyone got along. No trash talking.
About 2 weeks ago JBA performance had a dyno day. There where mostly mustangs there, but there where a few Firebird/Transams and Camaro/Z28s. Everyone got along. No trash talking.
11-02-2008, 06:55 PM
#7
6th Gear Member
Join Date: Dec 2007
Location: Long Island, moving to arizona soon
Posts: 7,386
I was just curious to see what the lil 4.6 would put down on the dyno.... so i went to a GM performance shop on their opening day with alll my LS1 buddies. Wow lil scary huh! All i have is a C&L aluminum intake and brenspeed tune. The tuner laughed at it and said, "ill guess 245 to the wheels!" I said i think 285... Keep in mind this is a DynoJet, the best dyno and most conservative! I put down 288 hp and 306 torque! Not bad, does everyone have similar results with intake/tune and Pypes MM?
why did the guy laugh at you was it b/c you had a mustang or was it somthing esle
11-03-2008, 02:54 AM
#10
2nd Gear Member
Thread Starter
Join Date: Apr 2008
Location: Orange County, CA
Posts: 227
ya the guy laughed cuz it's a mustang and the shop is called Orange County GM performance, or something along those lines.... lol!!! I was laughing so hard plus the dyno sheet says SAE approved so i guess the dynojet is SAE certified 