Wheelhop?
Is wheelhopping when it feels like the rear suspension is jackhammering up and down real hard under acceleration? I get that pretty bad sometimes and would like to plant the rear firmly on the ground, instead of having it seem like my car is about ready for lift-off. Is that simply a new set of LCA's, or how much else is involved?
|
A set of LCA's and a UCA normally resolves at least 90% of the problem.
|
Start with the LCAs, because they're a LOT easier to install. If they're enough to solve your problem, you're done at least for the time being.
If not, or if you add more power or do some other change that brings the hop back, you still have the UCA option, as well as LCA relocating brackets. Norm |
Sounds good! Are the LCA's a simple bolt in, or will it need aligned, springs compressed, etc?
|
They are cake to install. You'll need a floor jack, couple jack stands, a breaker bar, the right socket(s), and ideally a torque wrench for tightening the fasteners back down to 129 ft. lb. spec. If you re-use the factory fasteners it wouldn't hurt to put some fresh loctite back on them.
|
Originally Posted by Riptide
(Post 6980237)
They are cake to install. You'll need a floor jack, couple jack stands, a breaker bar, the right socket(s), and ideally a torque wrench for tightening the fasteners back down to 129 ft. lb. spec. If you re-use the factory fasteners it wouldn't hurt to put some fresh loctite back on them.
My father owns a general maintanence shop, so I have plenty of tools, car-lifts, and help :) |
They have the LCAs and then the LCAs with the relocating bracket...whats the difference?
Is it necessary to have the relocating brackets to help eliminate the wheelhop?? Whats the benefit of the relocation bracket? |
The brackets are usually only necessary if your car is lowered. Leastways from what I've read.
|
Relo brackets change the rear geometry by moving the instant center. It may not be necessary to use them if you only have a mild case of traction issues, though I can see why a parts supplier might decide to bundle the two items (LCAs & brackets) up as a kit.
I normally look for the least complicated remedy, and if it solves the problem you haven't bought things that you don't really need and might not ever install. Keep in mind that relo brackets for these cars is primarily a dragstrip mod, and the usual setting of the LCA holes - significantly lower than stock for more anti-squat (better initial launch "bite") - is generally too low for good handling (tends to make the car a little oversteerish due to rear axle steer effects). Stock ride height cars with relo brackets will be more oversteerish than lowered ones with relo brackets and using the same holes, meaning that relo brackets are probably best left for lowered S197's. |
Originally Posted by Riptide
(Post 6980473)
The brackets are usually only necessary if your car is lowered. Leastways from what I've read.
|
All times are GMT -5. The time now is 08:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands