Headers are finally in!!
01-15-2011, 10:24 PM
#1
4th Gear Member
Thread Starter
Join Date: Sep 2010
Location: Not sure
Posts: 1,724
Headers are finally in!!
Well after about 6 long hours, I can finally say those suckers are in. The install wasn't that bad, but if doing it yourself, be prepared to take apart ALOT of ****. To get everything in you MUST lift the motor off the motor mounts. Also I ended up having to remove the starter, steering knuckle, move the steering rack to remove the knuckle, and of coarse the splash guard and cross member. I highly wouldn't recommend doing this yourself, as you need one person on top in the engine compartment while the other is under the car. All an all I am very happy with the install and fitments of the pypes system and I would recommend them to anyone. I haven't started it yet since my whole house was sleeping, but I will tomorrow morning and also get a video up for you guys to hear.
Here you go. Sorry its kind of long so you can skip around, but I have never edited a video before.
http://www.youtube.com/watch?v=j-09g2of6ps
Snagged some pics though & also my father 1968 Bullitt fastback project
Here you go. Sorry its kind of long so you can skip around, but I have never edited a video before.
http://www.youtube.com/watch?v=j-09g2of6ps
Snagged some pics though & also my father 1968 Bullitt fastback project
Last edited by grabber blue gt; 01-16-2011 at 10:27 PM.
01-15-2011, 10:29 PM
#3
4th Gear Member
Thread Starter
Join Date: Sep 2010
Location: Not sure
Posts: 1,724
01-16-2011, 03:06 AM
#9
5th Gear Member
Join Date: Feb 2007
Location: Hawaii
Posts: 2,211
