I'm at it again... Build Round 4...
#172
Was having a problem with the meth not operating correctly. After looking it over. This is what I found... Swapped the wires around and everything seems to be working except the LED which a new one is already on the way.
#174
MAF didn't show up today. Got the first half of the exhaust welded and installed. Will need to go to a different lift to finish it up.
Put the body parts all back on.
All that's left to do is cut the interior panels for the SHR windows. Install the MAF when it gets here. Put the side skirts back on.
Put the body parts all back on.
All that's left to do is cut the interior panels for the SHR windows. Install the MAF when it gets here. Put the side skirts back on.
#175
I didn't have to cut any panels for the SHR louvers....not required in the instructions either:
http://www.silverhorseracing.com/200...-Instructions/
http://www.silverhorseracing.com/200...-Instructions/
#176
http://silverhorseracing.com/install...stallation.pdf
If you knew anything about my application then you'd know that I don't have an 05-09 interior in my car and rather I have a 10+ interior in my 05.
Thanks for trying to help. In the future it's better to just browse the thread and if I need help, I will ask...
#177
My favorite thing is when someone posts something that goes against what I am doing as if they have some found knowledge that I don't have.
http://silverhorseracing.com/install...stallation.pdf
If you knew anything about my application then you'd know that I don't have an 05-09 interior in my car and rather I have a 10+ interior in my 05.
Thanks for trying to help. In the future it's better to just browse the thread and if I need help, I will ask...
http://silverhorseracing.com/install...stallation.pdf
If you knew anything about my application then you'd know that I don't have an 05-09 interior in my car and rather I have a 10+ interior in my 05.
Thanks for trying to help. In the future it's better to just browse the thread and if I need help, I will ask...
Last edited by Roy_R; 01-31-2013 at 10:57 PM.