2011 GT/CS Front Valance done ... with Part numbers ...
#312
CS Valance (w/o fogs): BR3Z-17626-AA
BOSS Splitter: CR3Z-17626-AC
I'm not gonna be a forum ****, but you could have found the answer by going back like 2 pages.
Last edited by JimmyM; 02-24-2011 at 12:40 AM.
#313
My bad I saw the forum went on for 30 pages so I figured I would just ask. Especially cuz I was asking about the HID kits too.
Also does anyone know if there is a difference between the CS valance and the boss valance?
Also does anyone know if there is a difference between the CS valance and the boss valance?
#314
#320
I just put some brighter H11's in mine(GT/CS) until I am ready to go HID so I can confirm the H11 size. Now that I have learned how to get the airdam off without too much trouble and I can adjust the fogs focus, I will likely go HID on the fogs in a few weeks.
I did have a little issue with the H13 main headlights. On the driverside the new bulb was very tight and a few plastic shavings are on the headlight reflector now. I must have pushed too hard. I tried to wipe them out with a fiber towel and it just made it worse. A pipe cleaner got rid of some of the larger specks but I can't get the rest out. Compressed air didn't help. I could not figure out how to get the whole light assemble out so I have given up for now.
I also could not see how to adjust the focus on the headlights. Like the fog lights, they are pointing too low and just shine on the ground a few feet in front of the car. I can barely see light over the hood. The fogs were the same way but are better now after adjustement - just need to find the adjustment for the headlights and figure out how to clean the reflector. You can tell I am a newbie at this stuff.
I did have a little issue with the H13 main headlights. On the driverside the new bulb was very tight and a few plastic shavings are on the headlight reflector now. I must have pushed too hard. I tried to wipe them out with a fiber towel and it just made it worse. A pipe cleaner got rid of some of the larger specks but I can't get the rest out. Compressed air didn't help. I could not figure out how to get the whole light assemble out so I have given up for now.
I also could not see how to adjust the focus on the headlights. Like the fog lights, they are pointing too low and just shine on the ground a few feet in front of the car. I can barely see light over the hood. The fogs were the same way but are better now after adjustement - just need to find the adjustment for the headlights and figure out how to clean the reflector. You can tell I am a newbie at this stuff.