Headers, worth it?
Thread Starter
2nd Gear Member
Joined: Nov 2010
Posts: 212
From: Texas
I would kill for that nice lumpy idle of the stage 3s with cams, LOVE that sound! if I end up spending that much Im goind stage 3s.
1st Gear Member
Joined: May 2009
Posts: 110
From: San Diego, CA
Hi OP. I'm resurrecting this old thread cause there's a gazillion about the same thing here. Yes, they did provide a noticeable increase in throttle response and acceleration which I was convinced would NOT happen.
I got them mainly for the appearance and weight savings; tone as well. So the performance gains were completely unexpected but welcome
BTW I got my for $314 at LateModelResto. I'd rather pay $314 for headers made in the USA by workers feeding their families on our shores than $100 for Chinese knockoffs. Supporting them is the reason our jobs are leaving here to begin with. Go MADE IN THE USA.
Just me. Just sayin.
BTW, I weighed both sets and the stock iron headers were ~ 10lbs each. The JBA's were half that at ~5lbs each.
I got them mainly for the appearance and weight savings; tone as well. So the performance gains were completely unexpected but welcome
BTW I got my for $314 at LateModelResto. I'd rather pay $314 for headers made in the USA by workers feeding their families on our shores than $100 for Chinese knockoffs. Supporting them is the reason our jobs are leaving here to begin with. Go MADE IN THE USA.
Just me. Just sayin.
BTW, I weighed both sets and the stock iron headers were ~ 10lbs each. The JBA's were half that at ~5lbs each.
Thread
Thread Starter
Forum
Replies
Last Post
AMAlexLazarus
AmericanMuscle.com
3
Oct 2, 2015 08:06 AM
junior04
4.6L (1996-2004 Modular) Mustang
1
Sep 28, 2015 10:53 AM
treesloth
New Member Area
4
Sep 28, 2015 07:03 AM
