Flowmaster Muffler
FLOWMASTER, UNIVERSAL SUPER 44 SERIES TWO CHAMBER PERFORMANCE MUFFLER, SOLD INDIVIDUALLY -- UNIVERSAL FIT -- 2.50" Offset Inlet / Center Outlet, 4" x 9.5" x 13" All Black Finish Case. Gives A Distinct Advantage Over The Original 40 Series Muffler Delivering A Rich Deep Tone, Improved Flow Path Radius, Optimal Internal Flow and Sound Control. The Most Aggressive Deepest Sounding, Highest Performing Four Inch Case Street Muffler By Flowmaster!

so.....what do you think? is it worth it at $208 each![]

 

i think they sound amazing imo

 

any one have a sound clip?

 

I'm sure they sounds great but at 200+$ a piece... thats a little on the steep side, just my .02

CLIP:
http://youtube.com/watch?v=u4cEdTy21hs

 

$200 a piece is very steep. Two mufflers for $400 will end up costingas much asa fullcatback system that would include all your piping and tips....not to mention you would still have to pay to get mufflerswelded in.

Check to see if they are available without the black finish, I would imagine that this would help lower the cost. On a side note, I had Flowmaster 40's on an old Plymouth Duster and they sounded great.

 

$200 I don't think so, http://store.summitracing.com/egnsea...;y=10&x=30

were did you get a quote from for $208 each

 

Yeah for real. Those are $80 and your quoting $200. Thats crazy. Somebody's trying to scam.

 

You can also consider Midas' in-house performance muffler, Ravin. The Z33 is loud and angry sounding, with the higher numbers (Z44-Z66) being more subtle. I just put them on an '03 GT, and they sound a little more unique than everyone else's Flowmasters. They cost a little bit less, and you don't have to pay extra for a name. Let's face it; there's nothing too complicated about a hollow box with a few baffles welded in.

 

+1 on that one

 

different isnt always bad but those 44's sound amazing