My boss says his son ran a 10.99 in his 04 Mach with only bolt ons, full exhaust, predator, intake, short throw shifter, driveshaft, and 4.55 gear in the rear I think. I'm just wondering if that time is possible without a power adder of some kind. My boss likes to stretch the truth and I just found that time kinda hard to believe.

 

I wouldn't think that time would be possibile w/ any sort of power w/o drag slicks. Could be wrong though.

 

I doubt a Mach 1 can run 10s with no power adder, this new 578 rwhp shelby ran a 10.99, and it's supercharged...so i highly doubt that it's possible in a Mach 1 with no s/c

http://videos.streetfire.net/video/c...38009728c3.htm

 

Thats an understatment

Theres no way with just those bolt on's. Low 13's mabey if hes a really good driver.

 

Consider this and then you can form your own opinion. A heavily modded GT500 just ran 10.99 seconds in the 1/4, with 580 rwhp and 572 rwtq and a pro driver. My blown roush wont even break 12's and it has roughly 420 at the crank. He is full of it plain and simple

 

That's what I thought, most S/C Cobras have a hard time putting up those kind of numbers without doing something to the internals of the engine. Like I said, my boss loves to stretch the truth. I'm gonna ask him for some time slips.

 

I would call BS on your boss...nicely though, (he is your boss). W/o some huge shot or blower, or something, he is not reaching the N/A w/ a 4.6

 

EDIT: owned by the double post.

 

+1. I 've seen a N/A Mach 1 with bolt ons and drag radials consistently run 12.6-12.8. He ran a cobra that was there and he beat him. The Cobra ran a 12.8, he ran a 12.7. My point is, I doubt your boss could break 10's. This is one of those times where he's stretching the truth.

 

Yeah just ask for the slip, and when he cant produce one just go laugh at his ***!