04 mustang stroker kit dyno #'s
5th Gear Member
Joined: Mar 2008
Posts: 2,394
From: CT
Well i wil post the numbers when i get back into town. I can promise you those numbers are very real. My setup is 8.9 to 1 c/r with 5.0 stroker kit. Bbk shorty headers, comp cams 270 with stage two patriot heads, msd coils 90 mm maf with 30 lbs injectors and tuned with the diablo. Has two tunes track and street. My buddy builds race motors for his dragster and has a computer program that spits hp numbers with whatever setup you put into it and its been right on so far.
4.6L Section Moderator
Joined: Nov 2007
Posts: 10,286
From: South Central PA
Well i wil post the numbers when i get back into town. I can promise you those numbers are very real. My setup is 8.9 to 1 c/r with 5.0 stroker kit. Bbk shorty headers, comp cams 270 with stage two patriot heads, msd coils 90 mm maf with 30 lbs injectors and tuned with the diablo. Has two tunes track and street. My buddy builds race motors for his dragster and has a computer program that spits hp numbers with whatever setup you put into it and its been right on so far.
BAHAHAHAHAHAHAHAHAHAHA!!!!!!!! You come in with numbers for your car, and not only are they not in rwhp, they're not even real world! Thats ridiculous! I bet that that computer doesnt take into consideration drivetrain loss, accessory loss(because drag cars dont have accessories to drive), and fuel content, tune quality, or any of that. And if you had the car tuned, why would you be referencing having the numbers be made on a mustang dyno and then referencing a computer program that spit the numbers out at you?
You just made youre story a lot worse than it already was.
4th Gear Member
Joined: Jun 2010
Posts: 1,452
From: TEXAS
so you havent put the car on the dyno yet that was a horsepower computer guesstimate??
Thread Starter
Joined: Jul 2009
Posts: 8
From: va
Yes its been dyno'd i have the dyno sheets that ill post when i get home im on vacation. December i install the kenne bell 2.6 with 20 psi of boost. Even if they did inflate d the numbers the kenne bell is gonna pick it up!
2nd Gear Member
Joined: Jul 2011
Posts: 469
From: ky
if my aunt had ***** she would be my uncle>. lol
4th Gear Member
Joined: Jun 2010
Posts: 1,452
From: TEXAS
Oh the numbers you posted were actual rear wheel numbers on the dyno. I thought you were satying you guys used some type of horsepower guesstimate calculator by putting in the mods and engine size. But if you actually put it on the rollers and got those number then those are some decent numbers pimpin'.
