oxygen sensor tool?
 

What tool is there to remove the Oxygem sensor in 87-93 5.0's? Because theres no way mines coming out on an auto car without a special tool. I have seen the socket with the slot but i am not even sure if that would work.... Thanks

RE: oxygen sensor tool?
 

I use a boxed end wrench....either remove the plug from the wires or cut it off if you are going to replace it.

RE: oxygen sensor tool?
 

well im trying to put an h-pipe in the the sensor is pretty new so i dont wanna ruin it...

RE: oxygen sensor tool?
 

i used an open end wrench on mine... worked fine.;) I have an auto, there werent any special tools needed...:eek:

RE: oxygen sensor tool?
 

The plug might fit thru...that is what I used and it worked fine

RE: oxygen sensor tool?
 

+1 ^^^

It took me approximately 90 seconds to replace both oxygen sensors just using an ordinary wrench. Seemed like one of the easier things to do. Then again, I have the sn95 so maybe something is slightly different in yours.

RE: oxygen sensor tool?
 

try a line wrench if it's being a b!tch

like a closed end w/ a cut in it to fit over a line, if that doesn't do it, it's not coming out

RE: oxygen sensor tool?
 

i dont knwo how you guys ar euseing a wrench on the pass. sife i cant even fit a box and on let alone have room to swing it and the driver side i can get it on but there is no room to swing a 7/8" wrench.

RE: oxygen sensor tool?
 

wtf quit being a pussy and get that sensor off!

RE: oxygen sensor tool?
 

oh scratch that, sorry i took my h pipe off with the 02 sonsors on it, just unplugged em when i switched it to an o/r H then bolted em in my new o/r H nd bolted that up then plugged em into the wiring again. sorry havent done it with the h pipe still on....[&o]