Quick question I resurfaced my flywheel at my budy's machine shop but cant remember what position to install the new dowl pins in

 

the clutch should only line up one way and based on that you'll be able to see where dowl pins go in

 

agreed!

 

I sure hope you just didn't post ***** up the place, so you could reach 50 posts to go post in the classifieds cause none of your posts have substance, I'll be watching you if this is the case.

 

no, i read the post and commented, i am just acknowledging i read the post and have subscribed to it as well as further opinions develop i will iterate further. Keep your eye on me you'll find out i have a lot of good information.......chill daddie-0

 

and I'm at 51 posts now :P.....in case you didn't know...you still have to be here 30 days to post any classifieds...read the rules and get off my nuts.

 

you don't know half as much as you think you do Kid.

 

I've been here 2 years almost, I think I know the rules a lot better than you, don't tell me what to do, I manage this section in accordance with the rules....understand?...If your here to contribute, I apologize, but I call things how I see them....there to many that join and take their dump here and for only one purpose to sell stuff, I welcome you if otherwise be the case

 

ok sounds good to me bro, i hate posers too. feeling out the response rate of the forums, lot of them take weeks to answer and i tend to leave those behind.I like to know that whatever i'm helping with or being helped with gets prompt attention.Too often responses takes days or weeks and that SUX when youre trying to get S*^t done. I apologize for stepping on your toes and thx for the welcome, i'm sure youll be seeing a lot of me here.

Pze

 

^^^^^the response rate here is quick often but you have to weed through what is fact, what is opinion and what is misinfo.....another place to check out that has good response rate is sbftech.com...alot of technical info there and I like it's myths section about sbf tech