It starts but wont stay running!
#1
It starts but wont stay running!
I have a completely rebuild 306 from the ground up and after the build I went to start it for the first time and it fired right off and died. Didn't think much of it being the first turn of the key but i cant seem to get it to keep running now. Thought it was a fuel problem but that checked out and now on to ignition. 6al, blaster coil, msd cap and rotor, accel ingnition module. I think we discovered the coil is bad but not sure. Any ideas as to how to check the coil out? Any other problems it could be?
#4
ya I tried the the stock coil and the timing light went nuts. Thats why i figured the msd coil was bad. as far as timing goes I can't seem to get it close enough for it to even start now. I had it once and i let a guy mess with it and it got all screwed up and now i cant seem to get back to where i started. but could the reason it falls on its face be a vacuum leak? I have the bbk ssi intake and I have one port that I have no clue where it goes! HELP! Its a badass car but its not very badass sitting in the garage!
Thread
Thread Starter
Forum
Replies
Last Post
bryan616fl
4.6L (1996-2004 Modular) Mustang
10
01-25-2019 09:07 PM