intermitent stalling and running rough
#1
intermitent stalling and running rough
Since it was so nice out today I figured I'd pull my car out and do a few things, I got a mail order tune just to get the car to be safe and threw that in, hooked up an ignition box, tach, and threw on control arms. Well i decided to drive it a little and for the first 30 mins or so it ran perfect. no problems. then all of a sudden it stalled. I started it, and it ran perfect, then stalled after another minute. This time when i started it it didn't want to move and felt like it was running on 4 cylinders or something. so I stopped, unplugged the ignition box, it started fine and ran fine then started doing the same thing again. So I let it sit for maybe 5 minutes while I looked at everything then drove it home, and it took me about 15 mins or so to get home and it ran perfect the whole way. What's everyone's ideas? I sure don't know.
#3
pull your ECM out and re-clean the contacts on the J3 port
also, chances are really good that your IAC tables, and TB flow values are STILL incorrect, as the typical mail order tune is ****.
you should have bought a quarterhorse. I would have sent you my base tune to get you running
also, chances are really good that your IAC tables, and TB flow values are STILL incorrect, as the typical mail order tune is ****.
you should have bought a quarterhorse. I would have sent you my base tune to get you running
#4
I'm most likely still going to either get a quarter horse or get this one perfected but at wot the afr's are good so I can actually play with it a little. Also adder, by J3 port do you mean where the chip plugs in to? I also got a t4m0 and there was some what looked like wax on the plug for the chip. and I didn't wipe it out because I didn't know if it help the connection or not.
I will check for codes first thing tomorrow but can't start it now. the last time I started the car after 10:00 I got the cops called on me.
I will check for codes first thing tomorrow but can't start it now. the last time I started the car after 10:00 I got the cops called on me.
#5
dont do a damn thing with the codes
pull your ECM out and clean the "wax" off the port that the chip clips onto. Your chip isnt making a good contact. If you don't do this, you can/will fry your ECM and or chip
pull your ECM out and clean the "wax" off the port that the chip clips onto. Your chip isnt making a good contact. If you don't do this, you can/will fry your ECM and or chip
#7
well I cleaned off the j3 terminal today, and noticed the computer plug wasn't even all the way in, the bolt on the connector was only finger tight, so i took care of both and am driving the car to class tonight, and hopefully not gonna have any problems. lol.
#8
update???