The weld looks good but, someone came up with bright idea of putting sealer on it. It got me to thinking you could never be to sure about it being leak free so I did. That is what I dont like about the whole thing. It held pressure and water for a while so it was leak free to begin with and I put the sealer on just to C.M.A

 

^^^better to be safe than sorry, I'd of done the same thing

 

Looks good.

 

Well I got tired of driving 30 minutes to my buddies to work on my car cause that is where it has been for a few months now hanging out. I borrowed a trailer and brought it home today. I really dont have anywhere to work on it here but atleast it is here and I can just walk outside and work on it if desired.

I did get the tank installed today and got the carb put on again. I didnt have many tools here so what I could do was limited.

 

That sump looks pretty good. Ur DD looks sweet by the way

 

nice job man and i just seen your thread on sbftech.com so when are you gonna be able to fire it up?

and sorry i missedpart of your build 331

but what carb and intake is that on their?

 

Holley 650dp with a proform main body section. The intake is a victor jr.

 

Thanks I appreciate it. I was gonna use it as the toy but with fuel the price it is now. I needed something good on fuel to drive every day. So I left it alone.

 

..nice that should move out pretty good..

 

I can only hope so...

My concern is the heads being to much for my little motor. They have had a ton of work done to them. If it doesnt run good n/a it should haul the mail on the spray.