I'm board lol. What you guys think will i be able to run 11.5's or quicker with my set up
347
aluminum flywheel
aluminum uds
electrict fan
all supporting mods 70mm tb ect.
anderson cai
80 mm maf
have not decided if i want to go long tubes or not because of ca reasons
3.73's
aluminum driveshaft.
and and some mickey thompson et streets.
as for suspension goes
4cyl springs up front
torque box re enforcement, and thats it.. i want to see what the stock stuff does before i upgrade the suspension more. car will be launched at about 3500-4500.... sounds like noob question lol

 

yeah you should be pretty damn close to it or faster

 

quick question for you peeps. im trying to figure out my comp ratio. the pistons are suppose to be 9.5-1. i was looking it up and they are 9.5-1 with 64cc's and i have 58cc's. hoe woud i got calculating this? the calculaters on line suck lol..

 

not sure about the calculator but i think 10cc is ~= to 1 point of compression.. so maybe 10:1 or 10.1:1

 

if thats the case than im right where i want to be.

 

hard to make a guess since no top end is specified

 

it says in his sig "Port Matched afr 185's, rpm2 intake, custom cam "


im gussing you will be able to do it.

but dont assume stock suspention will do any good.

i would ATLEAST get subframes too...


i think you can do 11.50's once you get use to the car.

 

Going to have to drive the car like you stole it!

 

ahh my bad, was late last night...11.50's will be a breeze then

 

i Already have the subframes. My best 60 with the suspension i have now is 1.7. Cant wait to get this thing done.