5.0L General Discussion This section is for non-tech specific information pertaining to 5.0L Mustangs.

starting when warm problem

Thread Tools
 
Search this Thread
 
Old Feb 7, 2009 | 07:03 PM
  #1  
Stangnsnow2's Avatar
Stangnsnow2
Thread Starter
2nd Gear Member
 
Joined: Mar 2005
Posts: 174
From: PA
Default starting when warm problem

Heres a good one someone might be able to help me with. i can start my car perfectly fine when it is cold but if i drive around and go to start it (after pumping gas) it struggles to turn over and wont start. it cranks slow almost like the motor is hard to turn over.
i got a new starter twice now thinking that it might have been heat soaked but that isnt the problem. i changed the wire from the starter silenoid to the starter and it still does the same thing. i have no idea what is going on, however the battery was relocated to the trunk so im not sure of that has something to do with it but i honestly dont think it does. i need help because pop starting it is really starting to suck!!!
Old Feb 7, 2009 | 07:12 PM
  #2  
FivePointOhh's Avatar
FivePointOhh
in limbo
 
Joined: Jan 2007
Posts: 7,300
From: Iowa
Default

you may want to test you ICM or just replace it. its really cheap like 15 bucks i think.
Old Feb 8, 2009 | 02:54 AM
  #3  
ponyponer's Avatar
ponyponer
2nd Gear Member
 
Joined: May 2007
Posts: 287
From: jersey
Default

i'd go with ignition modual too. it will start malfunctioning when hot.
Old Feb 8, 2009 | 06:48 AM
  #4  
HACKGT350's Avatar
HACKGT350
6th Gear Member
 
Joined: Jan 2006
Posts: 6,635
From: new jersey
Default

i wouldnt go with that. it sounds to me like your timing is too far advanced. back it down a few degrees i bet it will start perfectly fine
Old Feb 8, 2009 | 08:34 AM
  #5  
Joel5.0's Avatar
Joel5.0
5th Gear Member
 
Joined: Jan 2006
Posts: 3,926
From: Puerto Rico
Default

Check/replace your grounds...... the main battery ground cable-to-block and make sure the block-to-frame ground strap is installed, and contact points are paint free. Grounds are very important......
Old Feb 8, 2009 | 10:23 AM
  #6  
Stangnsnow2's Avatar
Stangnsnow2
Thread Starter
2nd Gear Member
 
Joined: Mar 2005
Posts: 174
From: PA
Default

i know its not the timeing because i have advanced it and retarded it to see if that would do the trick. the grounds i think are fine i know the block strap is atleast, im going to check the others today and ill get back about it. the control module i dont see being the problem, i had a acel performance one that was malfunctioning but i used other old ones and a new one and i still had this problem. but i will also try switching them again today, thanks guys.
Old Oct 28, 2013 | 06:27 PM
  #7  
theslyfox's Avatar
theslyfox
 
Joined: Jul 2012
Posts: 12
From: Mississippi
Default

Hello i cant remember how to start a new thread so im just going to reply to this. i have an 88 gt, i converted to carb. its got a gm hei dizzy and holly 670 street avenger. i just got a new battery, volt gauge is reading 13v all the time while running and 12v from battery when off. so the battery is fine. in the morning my car will start great (cold start) but after driving it for a lil while, when it heats up if i cut my car off to go do something and go to start it shortly after it slow starts and after a couple tries the starter will go normal crank speed and start the vehicle. i cant figure it out, it only does it when the car warms up.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
djbigskrilla
2005-2014 Mustangs
24
Sep 20, 2022 01:04 AM
ShaneB26154
4.6L (1996-2004 Modular) Mustang
35
Mar 4, 2021 04:05 AM
bryan616fl
4.6L (1996-2004 Modular) Mustang
10
Jan 25, 2019 09:07 PM
jjwinel78
V6 (1994-2004) Mustangs
1
Aug 17, 2015 03:34 PM
KEM Motorworks
5.0L (1979-1995) Mustang
20
Aug 14, 2015 10:13 PM




All times are GMT -5. The time now is 04:26 AM.