mustangsneverdie

just replaced the heater core in my car. I started it up to get it warm and put the necessary water in it I started pouring out of the neck so I shut the car off, and waited about 30 secs or so before I tried to start it again.
now it will not run, it just keeps turning over .
i hear the fuel pump running,but its kinda hard for me to check for spark since I have no one hear with me right now. So tell me what you think it could be> I'm kinda irritated with it right now

calfroper_06

Water starting pouring out of the raditaor fill neck?

mustangsneverdie

yea overflowing, but nevermind I went back out and she fired right up and everytime afterwards.I bought a thermometer at advance yesterday to see how cold it was in my car(37.5*) and a few min. ago i put it up to the vent and it said that the air was 110* I like that a whole lot better lol

mustangsneverdie

O and mike,j,pro If y'all want to delete the thread go ahead since its not doing it anymore

mjr46

nah , no need to delete it, I wanna see how many people reply after the fact and tell you what to check.........that way we can rag on them for not reading more than the first post...lol

motorman524

Hows your D/S? Thats where I'd look. Maybe check the blinker fluid.

primetime5.0

muffler bearing is broken

projectresto83

Did you leave it in drive when you tried starting it

Tony71502

All you need to fix it is a left handed crescent wrench.

lxman1

I thought it was metric vise grips. Thanks for the info