Speaker sizes FOR 12-13 SHAKER 500
#1
Speaker sizes FOR 12-13 SHAKER 500
Does anyone have the dims for the subs ad 6x8 in the stock unit?
I know shelby have a set of kickers but wondering what the dims are to source other options...
Help?
I know shelby have a set of kickers but wondering what the dims are to source other options...
Help?
#4
I just measured the depth of one of the 8" subs I took out of my 2012, it is 3 5/8" deep. These have a threaded hole in the magnet to fasten them to the door panel to keep them from rattling. This means the depth is very critical.
I replaced mine with the Shelby Kicker subs. I'm using a Sony amp not the factory amp. The Kickers are a little deeper, they stick out about 1/4 farther than the factory subs. They come with there own speaker covers. I have the premium edition, so the Kicker speaker covers look crappy compared to the factory.
I replaced mine with the Shelby Kicker subs. I'm using a Sony amp not the factory amp. The Kickers are a little deeper, they stick out about 1/4 farther than the factory subs. They come with there own speaker covers. I have the premium edition, so the Kicker speaker covers look crappy compared to the factory.
Last edited by Chromeshadow; 07-09-2012 at 08:02 AM.
#7
The 6x8s are the standard size, there is lots of depth for any size 6x8 in both the door and the rear deck. All four are 4 ohm speakers. The factory rear speakers aren't too bad, you can see them when you look in the trunk. Here is a pic of the factory door speakers.
.
btw, the factory door subs are 1.2 ohm dual voice coil, the Kickers are 4 ohm single voice coil.
.
btw, the factory door subs are 1.2 ohm dual voice coil, the Kickers are 4 ohm single voice coil.
Thread
Thread Starter
Forum
Replies
Last Post
Boostaddict
Lethal Performance
2
09-08-2015 09:56 PM