i need to try to tighten fender down....it is the area by the cowl and windshield on drivers side...i have not had a chance to see if there is a bolt in this area i can't see or what.....does anybody know what is behind or under this area that holds the fender on? this area can be pushed down about a half an inch very easily...do to Halloween have to replace glass and thought would take care of this also if i don't have to disassemble the whole car.......thanx for any help don

 

there is a bolt in the door jamb and one behind the kick panel also underneath the car at the bottom of the fender all of those could be loose

 

i have checked and tighted those...the area of concern is on top of the fender...thanx for input don

 

I'm not sure what year your Stang is, but on my 66 there is a bolt at the top of the door jamb. If you open the door and look in at the top you can see it. I just disassembled my whole front end and noticed that this bolt was missing on the passengers side, and the fender was up against the windshield trim, causing a scuff in the paint. Sounds like you may have the same problem.

 

maybe because its just sheet metal and it bends so if you push down it it, its going to give some..........

 

check the thin sheet metal the bolts in the door jamb make shore its still atached to the fender.

 

thanx for input will look at it again to see if i'm miissing anything.....thanx again don