Did your bar fit this badly or did I get a bad one. I have the same gap on both sides. The Export brace fit like a glove. Didn't have any problems installing it even though I thought it would be a bear because it is on the rotisserie.

[IMG]local://upfiles/64293/C540F963526840269AB42DFE74CDCBCC.jpg[/IMG]

 

Time touse your hammer and dollyand make it fit You should be able to bend it into shape

 

haha that sucks.... jjust go to town on it with a hammer

 

The problem is that there is a gap athe the bottom as well. It almost looks like it was welded wrong. I dont want to chip or crack the chrome either.

 

return it? where did u buy it so i know where not to buy my new one

 

I got it at mustangs plus. I should be able to email them a pic at their web site right?

 

i would call there customer service line and ask them who to send it to or if the have a customer service email. i havnt had any problems with them so i dont know who to email

 

I just sent them an email with a pic of the problem. I hope they resolve this problem.

 

well if they wont give you a new one, ull need to get a paper bab and a fresh dog crap and put it on there door

 

Yeah, the one I got from NPD fit just about as well as yours does. I put the bolts in the upper holes and used a combination of a lead filled rubber hammer and steel drifts to pound and pull it into place. After getting all the bolts started, I was able to torque them down and pull it into place.

Good luck!
Jeff