maverick75

can someone give me the measurements(WxHxL) of a 69 rear valence?

thanks in advance

maverick75

bump

maverick75

anyone?

4reboy

I will try to do it in a little bit

maverick75

thanks

4reboy

well I can't find my tape measure right now but it is maybe 6 inches less than the total width of the car, and about 7 or 8 inches deep on the visible portion of it.

what do you need the measurements for? if you're trying to build one it will be very hard since it is contoured and has different shapes in it. PM me if I forget to give you better measurements tomorrow or whenever

maverick75

i'm trying to see if it will fit this ford maverick i'm working on let me measure it first then you can compare to a 69 stang valence.

maverick75

Alot of people had told me you can use a 69 stange valence in a maverick but i've never seen a confirmed case i just want to see if its in the same ballpark before i go out and buy one, then find out it doesnt fit.

i measured my mav and it looks like

6" height(were the rear panel meets the valence)
6" width from the bumper to were it should end(little under gas tank)
and 60" Lenght

4reboy

i got around 6.5" for height/width and around 58" for the length at the longest point. I don't know how great my measurements are but thats the best I could do. So it might work but I would be worried about the length the most.

maverick75

Thanks you, they seam pretty close i'm just going to buy one, if it doesnt fit i'll have to buy me a 69 stang ;-)