This is probably not a usual question but dose anyone know of any adapters or custom adapter companies that would make an adapter to make the
TR-3650 transmission have the same bolt pattern as a T-5 transmission ?
I know what you are thinking ( another 5.0 to 4.6 engine bay guy )wrong about that If I get up the nerve Ill spill it but till then ...
This is a mustang question.
Thanks

 

What engine are you bolting it to? Could you just buy a blow proof bell housing for the 3650?

 

sorry I was trying to delete this post earlier in day but did not no how.
Don't laugh and Ill spill the beans of my dream ..
I was needing to have a T5 Transmission so I could swap the bell housing with an adapter bell housing. I did not know that the 05 V6 manual transmission is a T5 so there is now no need to adapt the V6 Transmission to a T5 bolt pattern behind the bell housing because it is a T5 Trans and the adapter fits a T5
Stupid me.

 

If you must know I am thinking of putting a ford duratec 4 cylinder in my 05 V6 manual Transmission Mustang . Turbo charged to 280 hp or so of course . This is an attempt to have the lightest weight mustang as a duratec is all aluminum . This would also make the weight ratio almost 50/50 or close to it.