Well I've had all the stuff for my fuel system on the floor in my living room for almost a month but I do not have the lines or the fittings yet.My ? is I have the elimanater fuel pump 10an inlet and outlet,3/4 rails,10an fuel pickup tube,10an Y-block,2 100 micron fuel filters,fuel pump controller computer,pro series regulater with 10 an feeds and need to know what fittings I'm going to need and how many.I am going to buy the push type fuel line 10 an feed and 8 an return but dont know if someone might have a kit that they could just count the fittings and let me know how many and what ones they are so I can order all the fittings and lines to get this thing going.Last time I was at the dyno I made 521rwh of the highway after a 2 hour ride but was running out of fuel so I detuned it to 500rwh but its still dropping off power at 5grand with only a 2,95 pulley.I want to run a 2.75 pulley with a custom 8 inch crank pulley with race gas and should be able to put down hopefully around 575rwh but I have to get this fuel system in.Has anyone used the push type lines are they any good? cause I cant stand the smell of gas from the steel braided lines they emmit way to much smell for me.Any help would be appreciated