Hello All,

Was wondering if any of you guys have had problems with the leather on both door panels peeling off? I have tried for the past few months to get it to stick back on, but after a week or two it falls back off. Does anyone have any suggestions on what to do to fix it? Also if any of you have taken it somewhere to get fixed what did you end up spending?

Thanks in advance!!

 

I had the same problem a couple of years ago; check out the link it will help you.

https://mustangforums.com/forum/2005...gging-fix.html

 

Thanks for the quick response... I did a search, but apparently I did not use the right words... My only issue with this is I have already tried other things like super glue, and other adhesives, so I worry that this is no longer an option for me

 

The repair described in the link has worked for quite a few folks. Just follow the directions. If it doesn't hold, you either didn't follow directions or you have contaminated the surface(s) previously and the correct adhesive (NOT superglue) may not hold properly.

 

I actually just fixed mine tonight with a can of 3M 90 spray adhesive








I used one of these to flatten bubbles and push the edges back in their spot:



Yes you probably have one of these for dishes.

Be sure to let it sit at least an hour in a non-humid area and level. Good ingredients for success.

 

JCON I know you only did this a few days ago but how well is it holding up? I just bought some of that weldwood stuff mentioned in that repair, but haven't had time to do it yet.... I have tried numerous adhesives and they hold up for a week or so and then it starts falling off again

 

When I had my 06 I actually put vinyl with the diamond-punch pattern from a roll I ordered. I used 3M 90 Adhesive, and it held up for several years in the hot desert sun. The trick is to spray a good even layer and let both sides dry a bit according to the instructions. That's the important part... LET IT SIT a bit.

http://solutions.3m.com/wps/portal/3...=1114284885132

 

Thanks Tubra & JCON I will have to give that a shot and see how that works

 

Just make sure to use the 3M 90, but be careful, it's stickier than the slit in my nerf turbo football from my teen years...

 

HAHAHA!!!! Yea the last thing I tried was something very similar to the 3m stuff.. i got it from autozone and it is supposed to be for headliner, carpet, etc so I thought that should work pretty well and it did for about a week... the drivers side is not bad at all... the passenger side is horrible