cobrastang96

Okay guys, my goal is to make my 96 cobra exhaust sound deep and have that "hollow" sound. Right now I have stock manifolds minus 2 cats (still have 2 on), custom o/r x and flows, she sounds good, lots of compliments, but something is missing. My thoughts were, mac l/t's to a 3" h to my flows, but reading some "opinions" on l/t's, they make it quieter, others say deeper tone. Bottom line, all I want is a deeper more hollow tone and a few more ponies wouldn't hurt either. Thanks for any help!

superchargedSaleen.

Something like this?

Newgeneration

My friend, BORLA ATTACK CAT BACK EXHAUST

DocSnickers

I run Stainless Works they have a nice deep tone.

Newgeneration

Just make your pipes a little smaller from the cat. I have 3 " 1/2 inch and its throaty as ****

cobrastang96

what are you running saleen?

Borla Attack, never heard of them, who carries them? Help me with your last reply....

Stainless sounds good to.....so really I don't need to spend money I don't have for headers

DocSnickers

Mines running off stock headers and H pipe right now the video above was from the day they got put on. From what I have heard if you get their full setup with headers and midpipe it takes care of the drone at 2k rpms. Although I do not find the drone that bad it goes away pretty fast.

cobrastang96

I like these, but I'm partial to the "old school" mustang exhaust. The borla is just too "raspy", maybe with an h it would help,no offense, just my opinion, of course mine is kinda raspy 2 because of the x. The stainless steel was very close, but not sure they offer them on a 96 cobra.

DocSnickers

X pipe will change the sound too, if you want more of the old school mustang sound you should stick with an H pipe. Also a lot of that sound is the old engine, their push rods helped give them that sound. We can only get close now.

superchargedSaleen.

FRPP stingers.