Okay, first off I live in Oklahoma so there are no vehicle inspections so no worries about having to pass smog or anything. Because I am supercharged I have boost that is going from my plenum into my passenger side valve cover and I also have oil that is coming from my drivers side PCV valve into my intake system. Can I just remove both lines (the one from my passenger side valve cover to my plenum and the one that goes from my supercharger intake to my drivers side valve cover) put a breather on both valve covers and put in a plug where it went into my supercharger intake and a plug where it connected to my plenum?

Obviously this would reduce blow by, increase boost because I wouldn't be losing some from it getting pushed into my passenger side valve cover, decrease the oil going into my intake and therefore keep detonation chances lower... Am I thinking of this correctly or do I have missinformation? Let me know.

 

yes you can do that.

 

thats how mine is done. Its been like that since the engine was built and the intake stays clean. It keeps carbon and oil from building up on the valves too

 

how much boost would that add.My oil separator does nothing so i might remove it and do the same but if the boost goes any higher i dont know if i will