speed density(SD) question.
#1
speed density(SD) question.
I was wounding a few things since i'm new to 5.0.
Cams.what can i use? i was looking on ford website and some of the cams like the e303 cam and it says..
On EFI engines, performance camshafts work only with mass air induction systems. Will not work with Explorer EEC-V EFI. That mean it won't work cause i don't have a maf?
Cams.what can i use? i was looking on ford website and some of the cams like the e303 cam and it says..
On EFI engines, performance camshafts work only with mass air induction systems. Will not work with Explorer EEC-V EFI. That mean it won't work cause i don't have a maf?
#4
You can get a performance cam for a SD setup, it just needs proper lobe timing to maintain vacuum sufficient for MAP readings. The bigger problem is that while you can choose any cam you want (basically), nearly any cam you choose will require a professional tune unless you swap over to MAF, or unless you get a SD specific cam.
#5
you'll want to get a Mass Air Flow, a speed density system uses fixed air/fuel curves so if you do anything to take it away from stock airflow (i.e camshaft) it'll be totally lost. A mass air flow meter will learn on the fly and adjust your air/fuel mixture accordingly.
Check this article out:
http://www.musclemustangfastfords.co...n/viewall.html
Very informative.
Check this article out:
http://www.musclemustangfastfords.co...n/viewall.html
Very informative.
Thread
Thread Starter
Forum
Replies
Last Post
BeatnikFink
New Member Area
6
10-01-2015 08:00 PM
musnicki
Classic Mustang General Discussion
8
09-23-2015 07:11 AM
Daddys Girls GTs
5.0L (1979-1995) Mustang
3
09-14-2015 08:46 PM