any of you guys interested in a 351 punched out to a 418, with a stroker kit and custom machined cnc main caps? i am having it made at a machine shop in upstate ny.. i have a considerable doposit on it... ill sell my deposit for less than i have into it if someone else would like to finish it.. i am going to do a 347 stroker instead! thanks guys.. ohh yea the owner of the shop promiced me 650 rear wheel horsepower out of that set up! i baught the best of everyhting... thanks again

 

i'm relatively new to cars what would it take to put somethign like that in a v6 and would replacing the engine on a 6er save on car insurance just by going by the vin ?

 

In order to run that serious of a setup in a v6 you'd definatly need a new tranny, not to mention an whole new rear axle... I am sure there are other things im leaving out though - but those are the two major things I can think of...

 

suspension (k-member), fuel system, cooling system, and a whole bunch of othe ods and ends, and most likely lots of fabricating.