I was out earlier messin around and pull into a gas station,i look behind me and a 0range mach 1 was pullin in and i didnt think nething about it. I go in and when i come out he's standin beside my car and asks if i wanna line em up. i told him i asked him what it had and to pop the hood. I looked and all i see is a cai. I ask what alls done to it and he says it has full suspension and a new set of gears. He looks at mine and doesnt really ask much. so we finally end up goin to the highway. we line up at about 40mph and on the third "honk" we floor it,i spun when it changed gears(its an auto) and he gets about one car length ahead and it stays around 1 car length up to about 110mph and we slow down and run again i did a little better this time but still about the same results. He waves and we go our seperate ways.

 

by the way i have an 03 Gt AUTO,full bolt ons and suspension and he had a 03/04 MACH1 MANUAL.

 

good run

 

What are your mods? Some peoples deffenition to "full bolt-ons" is diff than others.

 

Good run man. Does Machs are bad a**.

 

cai,intake manifold,plenum,throttle body,udp's,intake spacer,maf,grantelli coils,dyno tune,lca's,uca's,bilstein HD shock and strut package,kenny brown strut and shock braces,front and rear sways bars,bbk shorty headers,o/r x-pipe and slp lm1's...im probly forgettin some stuff...it dynoed at 287rwhp

 

dam, **** auto =/

 

those numbers are very high for only a few non-suspension bolt ons. But im not very familiar with the gains of a 2v but 60rwhp gain from those mods is doubtful. either way good race

 

i know and it was on a dynometer...im pretty sure it has way more then what the eye can see...i didnt do the mods it came with everything from a car dealer

 

a....powerdyne dynometer?