How hard would it be to swap a 03-04 cobra motor into a 97 cobra?

 

Easy if you have the complete wire harness. Take a lot of pictures of how one fits in the 03/04 and just stick it in there.

 

honestly you would most likely spend alot more money swapping an 03/04 cobra engine in than building your own, they aren't cheap, if you come across one cheap it could be done fairly easily...

 

im not 100% sure but the 03/04 had different trans then the 97, but like said by the time u get the harness computer transmission, clutch, and what ever else you might need clutch cables drive shafts etc.. its going to get quite expensive

 

If he get a T56 he'll have two issues. 1) electronic speedo in the T56 and 2) the 96-98 Cobras have the cross member moved back a few inches.

Everything else is as easy as Sunday morning.

 

He didn't say anything about money, he only asked how hard it would be. I agree though, the hardest part would be coughing up the money for one. Much cheaper to build your own.

 

yeah, but this is a forum and he is looking for help, why would i steer him in a direction where he would spend much more money for the same power than if he went an alternate route.

then you go and agree with me... wtf was the point of that first sentence.


wait this 1 was fine lol.

 

repost.

 

repost.x2

took forever to load.

 

^ HAHA you got excited with the send button! lol