Fueling needs after TVS swap
#1
Fueling needs after TVS swap
The VMP 2.3TVS is the blower I'll be replacing my Heaton with. With a pulley set up to hit about 600rwhp. My question is:
What as far as my fueling system will need and upgrade?
I was thinking a new hat to hold dual FGT pumps and 60lb injectors.
Will I also need new rails and possibly lines?
And what size MAF would best suit this setup?
Thanks in advance.
What as far as my fueling system will need and upgrade?
I was thinking a new hat to hold dual FGT pumps and 60lb injectors.
Will I also need new rails and possibly lines?
And what size MAF would best suit this setup?
Thanks in advance.
Last edited by crysalis_01; 03-24-2013 at 02:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM