ok i have long tube headers ,with an h pipe and and some high flow cats im gonna fab on the h pipe ,gaskets for the headers and back end o2 sensor elimanators what else do i need to finish the job besides the muffler system and does anybody know where i have to fab the cat on the h pipe ?

and im gonna swap out my stock v6 rear end for a 8.8 are their any other parts i have to change or upgrade since im putting i gt back end on for example bigger tires or wheels , drive shaft etc ...... any other parts ? ( i have stock 16 tires and wheels and my car is an automactic v6 )

 

dude. seriously. not to be a dick but you asked these same questions in the other threads. and i answered them there. no need for a new thread

 

im just putting them all in one so i dont have so many to look at .

 

exactly...you should have told me and i would have merged them.....not really much to do now since you have like 10 different threads lol.....but from now on try putting most of your q's in one thread like you did on this one

 

ok , how do i get rid of those other threads

 

i will clean it up for you tomorrow

 

thanks im new to all this , but i added one question since im gonna fab those cats on the h pipe were do i fab them on the h pipe?

 

anyone?

 

I would put them right after the front flanges. Also you missed the front O2 extentions in your list. If you are going to be using MIL eliminators then in theory you should not have to put in a bung in for the rear O2's, because the eliminators just relay the signal back to the computer that everything is running fine.