THR EXCLUSIVE... the HPS 2V Intake is HERE!!
2nd Gear Member
Joined: Apr 2006
Posts: 280
From: Chicago
RE: Dyno Numbers for the HPS
1) you can buy these intakes direct from HPS... no 'dealer' required. (unless this 'deal' does better than $695 shipped)
2) They make good power, with little to no increase in intake temps
3) You're gonna need an NPI elbow/intake gasket and a fitting for the heater hose (not a big, about $30 total)
4) You may want to think about having a Dremel handy if you're freakish (like me) about your runners and plenum being completely smooth (couple hour job, but worth it IMHO)
5) it's virgin 319 ALUMINIUM, not 'aluminium steel' (whatever that is)
Any other q's... PM me.
2) They make good power, with little to no increase in intake temps
3) You're gonna need an NPI elbow/intake gasket and a fitting for the heater hose (not a big, about $30 total)
4) You may want to think about having a Dremel handy if you're freakish (like me) about your runners and plenum being completely smooth (couple hour job, but worth it IMHO)
5) it's virgin 319 ALUMINIUM, not 'aluminium steel' (whatever that is)
Any other q's... PM me.
Thread
Thread Starter
Forum
Replies
Last Post
