FAIL SAFE MODE
#1
FAIL SAFE MODE
Has anyone one else had this come up where the car hit the torque limit( at least that is what STEEDA is saying) and shuts 2 cylinders down? I just put the charge motion plates, 4:10 gears and Flywheel in. and I cant seem to get above 4k RPM. Dont know if it is the new programing or what.
#2
RE: FAIL SAFE MODE
ORIGINAL: Loomis
Has anyone one else had this come up where the car hit the torque limit( at least that is what STEEDA is saying) and shuts 2 cylinders down? I just put the charge motion plates, 4:10 gears and Flywheel in. and I cant seem to get above 4k RPM. Dont know if it is the new programing or what.
Has anyone one else had this come up where the car hit the torque limit( at least that is what STEEDA is saying) and shuts 2 cylinders down? I just put the charge motion plates, 4:10 gears and Flywheel in. and I cant seem to get above 4k RPM. Dont know if it is the new programing or what.
#4
RE: FAIL SAFE MODE
ORIGINAL: Loomis
Did get the new programs from STEEDA and loaded them. But it still trips the fail safe mode.
Did get the new programs from STEEDA and loaded them. But it still trips the fail safe mode.
#5
RE: FAIL SAFE MODE
Hey I apprecate all the help, I am going to try to re-stall them again tonight. Before I send the SCT box back to STEEDA for them to check the programing. Thinking of running all the programs back through, chip, charge and gear just to be safe. If not looks like a drive to Pompano Beach to STEEDA, YUCK![sm=sigh.gif]
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM