Replacing My Slave Cylinder... What else??
#1
Replacing My Slave Cylinder... What else??
Ok so I am finally replacing my throwoutbearing/slave cylinder this month. Gonna go with an OEM one since I have read more bad than good with all of the aftermarket ones. Had a Ram HDX clutch installed last summer and in my excitement, i never had the slave/throwout replaced. The mechanic i had do it should have said something. Needless to say i will not be going back to him.
Anyways, I will be replacing the pilot bearing, with a FRPP one, and the flywheel with a Ram billet steel one. Only other thing i can think of replacing while the tranny is out is the rear main seal.
Just looking for opinions and whatnot about what else i should have replaced while the tranhy is out. ??
Anyways, I will be replacing the pilot bearing, with a FRPP one, and the flywheel with a Ram billet steel one. Only other thing i can think of replacing while the tranny is out is the rear main seal.
Just looking for opinions and whatnot about what else i should have replaced while the tranhy is out. ??
Thread
Thread Starter
Forum
Replies
Last Post