Tubular k member
#2
the QA1 K-member allows for use of stock springs, but the QA1 tubular arms, do not.
I run eibach drags with my stock arms on a QA1 K-member. If I could do it over again, I'd be running an AJE k-member and Tubular A-arms. Theirs has the spring pockets that allow for stock style spring use!
and your strut selection is based on the spindle you are using... NOT the K-member
I run eibach drags with my stock arms on a QA1 K-member. If I could do it over again, I'd be running an AJE k-member and Tubular A-arms. Theirs has the spring pockets that allow for stock style spring use!
and your strut selection is based on the spindle you are using... NOT the K-member
#3
the QA1 K-member allows for use of stock springs, but the QA1 tubular arms, do not.
I run eibach drags with my stock arms on a QA1 K-member. If I could do it over again, I'd be running an AJE k-member and Tubular A-arms. Theirs has the spring pockets that allow for stock style spring use!
and your strut selection is based on the spindle you are using... NOT the K-member
I run eibach drags with my stock arms on a QA1 K-member. If I could do it over again, I'd be running an AJE k-member and Tubular A-arms. Theirs has the spring pockets that allow for stock style spring use!
and your strut selection is based on the spindle you are using... NOT the K-member
#4
Ehh? Not really, Im using SN95 spindles with fox struts. People say get sn95 struts because its like... 2% easier to install the struts.
With most tubular control arms they require coil over conversions. Not tubular K members.
With most tubular control arms they require coil over conversions. Not tubular K members.
Thread
Thread Starter
Forum
Replies
Last Post
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
10-05-2015 07:16 AM