jman83

Igot a 5.o block (c7te- ca) rpm heads and a f cam that im have been putting togetheralso a powerdyne supercharger that i had got of craigsliist. I know it is all good cause I heard the car before stuff was pulled off anyways what do I set the timing on the timing chain, I dont have the cam card. what do I set the ting on the distributer, I believe the powerdyne said 6 degree dont remember if that was adv. or retard any help would be nice. And yes I have the burned dioblo chip maf injectors ebroch intake rocker arms and push rods from buddy so it ran as a team on his mine should be the same I would think ($2750) his was a 95 stang mine is a95 stang the chip was burned by mv perfomance in alburn ga. the block is a block I am rebuilding for my build truck block but is a roller

Venomantidote95

thats prolly 6* base.

AdderMk2

set the chain dot to dot, and set your distributor around 6BTDC

jman83

kool thanks

jman83

will the pushrods work from his set up that i got from him or is there a chance I need shorter or longer ones

mjr46

I have my base set at 14...but then again I control my boost with a crane boost retard.......how many lbs is the s/c your running???

jman83

10 psi pully

mjr46

if you don't have a boost retard then set base to 6 to be conservative as stated