View Single Post
Old 07-31-2013, 12:17 AM   #4
toybreaker
2nd Gear Member

 
Join Date: May 2009
Vehicle: 1970 Ford Mustang coupe
Location: Guam
Posts: 173
toybreaker
Default

Quote:
Originally Posted by 1slow67 View Post
Just make sure you brace the front of the transmission so it doesn't droop and bent the crossmember.
You can use a broom handle (or pipe/solid bar stock) across the "frame rails"
with bolts sticking out of the lowest bell housing bolts to hold the trans in place.
As long as you don't move the car violently the trans will not move at all.
Putting nuts with fender washers on the front side of the broom will stop it from rolling out from under the bolts through the bell housing too.
toybreaker is offline   Reply With Quote